TALARIA XXX KEY PROGRAMMING

The Talaria XXX unlocks using an RFID key. The bike comes with two such RFID keys. Each of these keys are registered on the RFID reader as “Admin Keys”. You can use these keys to program more keys on to the bike.

  • Turn the bike on
  • Hold one of the admin keys on the reader, do not remove it
  • The normal bike activate tones will go
  • After 5 seconds, there will be 5 rising beeps, "Remove the admin key" 
    • Note: (If you hold it longer still, You’ll hear 5 descending notes indicating that you’ve left “add keys” mode & entered "remove keys" mode and have gone to far and need to start over by turning off bike and start from the beginning.
  • Place the new RFID key on the reader, it will make a lot of tones
  • Remove the new RFID key
  • Turn off the bike

After that, the new “non-admin” key will work for turning the bike on-and-off, but will NOT be able to activate the “add more keys” mode.

You should not “clone” the Admin keys. It is in your best interest to follow these steps, make a few “secondary” keys and store them away in a safe place. This way if you lose a key while out, you can easily replace it by just scanning in more keys.